8
Tag Feeder Manual
For proper operation of the machine, periodic maintenance is required and
only takes a few minutes to complete.
Clean the feed belts and discharge belts as needed, no more than weekly
using a rag and isopropyl alcohol. Isopropyl alcohol is the best solution for
refreshing the belts and cleaning the dust off them. It can be purchased at
any Walgreens / CVS type stores.
As you are cleaning the belts, visually check the condition of the timing
belts to look for fraying or cracking – replace as needed.
Gate o-rings will need to be rotated as they develop at spots on them. The
best way to determine if they need to be rotated is that the machine will start
feeding doubles.
To adjust, simply loosen the screw and rotate the o-ring spool 1/8”.
Finally, a clean machine is a happy machine. Make sure to blow off dust
and contaminants on a regular basis.
4 Maintenance
To Next Page
Loading...