4
Tag Feeder Manual
Depending on available locations, the trigger sensor and reector should
be mounted in an area along the conveyor that will allow it to detect
the bags as they come into the sewing machine. It is important that the
location is not interfered with by operators which could result in miss-
feeds. The provided mounting hardware will allow you to mount the
sensor and reector directly on the sewing machine frame.
Slide and set the pressure plate at the full rear/up position. Secure in
place with the detent knob.
Raise the gates a couple turns off the belt by turning the knob clockwise.
Insert a single tag between the separators and feed belts. Begin turning
one of the separator knobs counter clockwise while you slide the tag
back and forth until a slight drag is made. Then repeat with the second
separator. Once both are equally set, turn both knobs additionally
counter clockwise ¼ turn.
With a tag in position at the separators, add another 1-2” of tags to the
stack. Move the wedge in just so it makes contact with the rear of the
tags.
Continue loading product in the product tray. When loaded, release the
detent knob and allow the pressure plate to make contact with the stack.
Make sure the detent knob is in the full up position so that the pressure
plate slides freely.
Plug the machine into a properly grounded 120V outlet and release the
Estop button.
Mounting
Trigger Sensor
Set the Gates
Set the Wedge
Load Product
Turn on Power
To Next Page
Loading...