Setting up your Water Leak Sensor
Follow instructions and get your compatible Zigbee hub setup. 1.
To open the back cover of your Water Leak Sensor, use a screw-
driver to remove the screws. Then insert two batteries inside
the sensor.
2.
Configure the Water Leak Sensor with your Zigbee hub. (For
help and troubleshooting related to configure device with
Zigbee hub, visit the hub’s user manual)
3.
To factory reset the sensor, long press the inside button of the
sensor to place it in pairing mode(Figure 1). Release the hold
until you see the red LED turn on. After you release the hold,
LED will change to a fast blinking blue light indicating the
sensor is now ready for set up.
4.
Put the sensor’s back cover back and replace the screws.5.
To Next Page
Loading...