Pairing with SmartThings
Pairing Steps:
Compatible Devices: SmartThings Hub 2015 & 2018, Aeotec
App: SmartThings App
Open “SmartThings” App, go to the devices page.1.
Tap “+” icon on top right, click “Add device”.2.
Open the back cover of your Water Leak Sensor with a screw-
driver, insert two AAA batteries, if the blue light is not blinking
rapidly, please press the button for about 3s, when the read
light is on, release the button, the blue light will blink rapidly
indicating that it is in pairing mode.
3.
Then choose “Scan for nearby devices”, SmartThings is scan-
ning.
4.
The “Water Leak Sensor” icon will show on the page, indicat-
ing that pairing is completed.
5.
You can rename the Water Leak Sensor.6.
To Next Page
Loading...