Figure 1
IMPORTANT:
Read and understand all of the instructions and safety
information in this manual before operating or servicing this tool.
COMFORT CRIMP
®
TBM21E / TBM25S / TBM4BB SHURE STAKE
®
TOOL
For Installing Color-Keyed
®
Copper & Alumunum
Lugs and Splices, C-Taps and Pigtails
In the event the SHURE STAKE
®
MECHANISM must be released, please see Figure 4.
TA01299 E Page 1 of 2
1. Open handles
fully.
2. Depress wheel
release button
and rotate
wheel to proper
die nest. Allow
wheel to lock
into position
by releasing
button.
For Use With Color-Keyed
®
Lugs,
Splices, Pigtails and Colored-Keyed
®
C-Taps
Figure 3
Figure 2
1.1
1.0
INSTRUCTIONS FOR USE
Color coded dots match color of terminal and/or splice for quick identi cation of crimp nest
3. Insert stripped
wire into
connector
and position
assembly in the
tool as shown.
4. Close handles
until the SHURE
STAKE
®
mechanism
cycle has been
completed.
5. Perform several
equally spaced
crimps on each
terminal barrel.
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
To Next Page
Need help?
General
