Factory Alignment Specification of normal SIACP
Page 13 of 19
3. Press down “power” key on keyboard, power on if it is on “power off” status , release the
“power” key 2~5 second later , the LED on IR board will flash after upgrade begin, the TV set
will start up if upgrade succeed.The LED is on but no flash if upgrade fail,check the set and
try again.
Upgrade without loader(The TV set should be able to display normally):
1. Save the new software file(*.pkg) in the root directory of USB, and modify it’s name as
upgrade.pkg.
2. Plug in the USB.
3. Upgrade the SW follow the indication display on the screen
Appendix r “Modify panel ID with Hyper terminal”
ķ. Connect the PC to the board using a special serial device (USB or COMx).
ĸ. Provide a correct voltage to the board
Ĺ. Save the password file “password for hyperTerminal.txt” to your computer.
'?07?䇗䆩䇈ᯢ
ᏆথᏗ?SDVVZRUGI
ĺ. Start HyperTerminal “HyperTrm.exe” in your computer.
Ļ. Fill the name.
ļ. Select the Com Port you are using.
Ľ. Set the items as below picture.
To Next Page
Loading...
