GB-6
ASSEMBLY INSTRUCTIONS
1. Unscrew the 3 screws under the base
2. Gently pull on the power cord. Pass the power cord through the hole in one of the two parts
of the base planned for this purpose.
3. Adjust the two parts of the base by sliding and "clip" together, then adjust the base to the
fan body. Insert the 3 screw in the base holes and well screw.
4. Finally, put the power cord into the path for this purpose under the base, to ensure the
necessary stability to your fan.
Air outlet
LED display
Base
Control panel and remote control storage
To Next Page
Loading...
