service@thorgroup.us +1 877-288-8099
Step 8
1. Check the edge of the middle plate of the drawer assembly (Part #52) and make sure the side
with edge is facing up; otherwise you will get to wrong folding direction (see the picture below
with wrong folding direction with “×”). Be careful with the folding process.
2. Use 8 pcs 5/32 flat Philip’s screw heads (Part # 70) install the bottom plate of drawer assembly
(Part# 52.4) to the middle plate (Part# 52.3)
3. Use 8 pcs 5/32 flat Philip’s screw heads (Part # 70) install the front plate of drawer (Part#
assembly to the middle plate (Part# 52.1 and 52.2)
To Next Page
Loading...