Why won't the engine start on my ThorWorks Industries Construction Equipment?
If the engine of your ThorWorks Industries Construction Equipment won't start, it might be due to fuel in the oil crankcase. In this case, you should clean the crankcase and remember to keep the fuel shut-off valve in the OFF position when you're finished using the equipment.
What to do if the material pump material flow is reduced in ThorWorks Industries Construction Equipment?
Reduced material flow in your ThorWorks Industries Construction Equipment's material pump can stem from several causes: * A plugged basket strainer: Clean the basket. * Plumbing leading to the pump is plugged: Unplug it. * A worn pump: It may need new gears or replacement. * A slipping belt: Tighten the belt. * A relief valve stuck open: Clean the seat.
Why LP gas burner will not stay lit in ThorWorks Industries Construction Equipment?
If the LP gas burner on your ThorWorks Industries Construction Equipment won't stay lit, the thermocouple likely needs to be replaced.
General| Brand | ThorWorks Industries |
|---|---|
| Model | SealMaster 300 Series |
| Category | Construction Equipment |
| Language | English |
Essential safety measures and awareness for operating the equipment.
Critical warnings and restrictions to prevent hazards during operation.
Procedures for treating molten asphalt cement burns and shock.
Step-by-step guide for heating asphalt material using the burner.
Procedures for starting the engine and initial setup.
Instructions for circulating and pumping asphalt material.
Guidance on using the spray bar for material application.
Steps for flushing the system with diesel fuel.
Practical advice for routine equipment maintenance.
Heating asphalt material with the hydraulic drive system.
Engine start-up procedures for hydraulic drive models.
Pumping asphalt material with the hydraulic drive system.
Spray bar usage for hydraulic drive configurations.
Flushing the hydraulic system with diesel fuel.
Maintenance recommendations for hydraulic drive units.
Periodic maintenance tasks and their recommended intervals.
Diagrams for electrical connections of brakes and lights.
Comprehensive list of parts for the Roper 1-1/4" pump.
Exploded view and part identification for the Roper 1-1/4" pump.
Comprehensive list of parts for the Roper 2" pump.
Exploded view and part identification for the Roper 2" pump.
To Next Page