Thunderobot K87R - Page 3

3
Layout and Functionality
Installation: No driver software installation required. Plug and play.
Interface: USB
Predefined gaming mode backlight (FN + 1~8) and user-defined backlight (FN +
9~0).
Nine lighting modes (FN + Ins to change the lighting mode), backlight brightness
control (FN + Up/Down), backlight speed control (FN + Left/Right).
Backlight modes (keys lit)
• FN + 1: Gaming mode 1 (FPS) (ASDW, Up, Down, Left, Right, ESC)
• FN + 2: Gaming mode 2 (CF) (ASDW, CTRL, SHIFT, ALT, SPACE, RGQEB, 1~5, TAB,
F1~F3, HOME, END, PGUP, PGDN, PRTSC, SCLK)
• FN + 3: Gaming mode 3 (COD) (QWERTASDFGCV, 1~7, CTRL, SHIFT)
• FN + 4: Gaming mode 4 (RTS) (QWERASDGXZFKLHMNUYTP, SPACE, 1~0, CTRL,
SHIFT, ALT)
• FN + 5: Gaming mode 5 (League of Legends, all) (QWERDGFBV, CTRL, ALT,
TAB, SPACE, 1~6, ESC)
• FN + 6: Gaming mode 6 (Racing) (ASDWR, Up, Down, Left, Right, CTRL, SHIFT,
ALT)
• FN + 7: Gaming mode 7 (NBA) (AFSWRE, CTRL, SHIFT, ALT, SPACE, Up, Down,
Left, Right, ZXCV, 1~4)
• FN + 8: Gaming mode 8 (League of Legends, limited) (QWERDFB, 1~6)
• FN + 9: User-defined mode 1
• FN + 0: User-defined mode 2
Support of WIN key lock (FN + WIN).
Front RGB striplight: FN + PAUSE to switch the front striplight mode (streamer –
steady on – breathing – neon – off). In steady on or breathing mode, use FN + [-] to
change the colour (red – green – blue – yellow – cyan – purple – white), and use FN
+ [+] to adjust the speed.
Factory reset: FN + PGUP for five seconds.