Procedures:
1. Take out the gas cooker from its package and check if any accessories missing.
2. Put the accessories such as pan support on to the gas cooker.
3. Turn the gas inlet (at the rear side of the gas cooker) to a proper angle, connect to the gas tube
and fasten with tube clamp (tube and clamp to be prepared by user).
4. Turn on the gas regulator and check the connection with detergent for
Requirement:
1. Surface of the installation platform must be made of concrete stuff or other flame retardant
materials.
2. Ample space of at least 150mm must be left between the wall an the body of the gas cooker and
a minimum 800mm clearance above the gas cooker.
3. Gas tube should be 1~1.5 meter in length and should not touch the cooker body.
4. The gas cooler should be located no less than 1 meter away from gas tank.
Usage
Ignition
Turn on the gas supply, push down and turn the switch knob counter clockwise till a sound of’ click’
heard. The electro spark will then ignite the gas from the ignition device. Meanwhile the burner lit. Then
release the switch knob.
In event of the burner flames being accidentally extinguished, turn off the burner control and do not
attempt to re-ignite the burner for at least 1min.
Flame adjustment
Turn the switch knob to the position according to the fig illustrated below for the desired flame size.
To Next Page
Loading...
General