Tiger WEEDOO - Final Preparation for Operation

ASSEMBLY
© 2019 Alamo Group Inc.
ASSEMBLY
Assembly Section 2-5
FINAL PREPARATION FOR OPERATION
Place operator’s safety and operation decals on the valve mount and hydraulic tank where they are clearly visible
to the operator. These decals should be understood by each operator of the machine in conjunction with the
Safety and Operation Sections of this book. The decals are to be maintained in good condition as a reminder to
the operator, and should be replaced if damaged.
Finally, all bosses, pins and pivot points will need to be greased as instructed in the Maintenance Section of this
manual. The hydraulic reservoir can also be lled with the recommended uid (see Maintenance Section) and the
lter installed in the the tank. Double check all ttings and fasteners BEFORE starting the boat. Also secure any
loose hoses together with zip ties and wrap with split hoses where friction may occur on the hoses.
WARNING!
BEFORE starting or operating the mower you must read and understand
the Safety and Operation Sections of this manual completely.
BE SURE THE BALL VALVES ARE OPEN! Start mower and allow instruments to stabilize. Using a piece of
paper or cardboard as noted in the Safety and Maintenance Sections, check all ttings and connections for
hydraulic leaks.
If a leak is found, you must shut down the mower, set the cutter on the ground. Before attempting to x the leak,
you must actuate the lift valve handles several times to relieve any pressure in the lines.
Before operating the mower, the cutter head and boom should be slowly moved throughout the full range of
motion. Watch for any condition that would cause pinching or excess stress on the hoses.
MOWER TESTING
Take the boat to a place free of loose objects in the water. Operate the cylinders through their full range of
motion again, to clear the lines of air. Follow the instructions in the Operation Section to operate the mower.
Vibration of the mower should be minimal at all times.
If any parts of this Assembly Section, or any other section of this manual
are not clearly understood you must contact your dealer or the address on
the front of this manual for assistance!