17
REFRIGERATOR COMPARTMENTS ARE TOO WARM
• The door is opened frequently.
• A large amount of warm or hot food was stored recently.
• The refrigerator has been disconnected for a long time.
FOOD IS FROZEN
• The temperature was set too low.
THERE IS „WATER FLOW“ NOISE FROM INSIDE THE REFRIGERATOR
• It‘s a normal phenomenon, caused by the ow of refrigerant.
THERE ARE WATERDROPS AROUND THE REFRIGERATOR CASING OR DOOR GAP
•
It‘s a normal phenomenon, the moisture will condense to water when it touches a cold
surface of the refrigerator.
THE COMPRESSOR IS SLIGHTLY NOISY WHEN STARTING
• It‘s a normal phenomenon, the noise will be reduced after the compressor works stably.
CODE E1 DISPLAYED
• Possible cause: low voltage to fridge. Adjust the battery protection from High to Medium or
from Medium to Low.
CODE E2 DISPLAYED
• Possible cause: condenser fan is overloaded. Disconnect power to fridge for 5 minutes &
restart. If the code shows again, contact manufacturer for service.
CODE E3 DISPLAYED
•
Possible cause: the compressor starts too frequently. Disconnect power to fridge for 5 minutes
& re-start. If the code shows again, contact manufacturer for service.
CODE E4 DISPLAYED
• Possible cause: compressor not kicking in. Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
CODE E5 DISPLAYED
• Possible cause: overheating of the compressor & electronics. Disconnect power to fridge for 5
minutes & re-start. If the code shows again, contact manufacturer for service.
CODE E6 DISPLAYED
• Possible cause: no parameter can be detected by the controller. Disconnect power to fridge for
5 minutes & re-start. If the code shows again, contact manufacturer for service.
CODE E7 OR E8 DISPLAYED
• Possible cause: temperature sensor is faulty. Contact manufacturer for service.
To Next Page
Loading...