03
减震供电安装方式 支架吸盘安装方式
Install shock-absorbing power supply system Install suction disc platform
Install the battery plate,then pull the lever to lock.
Note: Make sure the cross connector is installed
before mounting the suction discs.
Mount the suction discs to a smooth surface,then press the
suction valve until the white ring is covered by the valve. (If the
white ring moves out of the valve in a short period of time,
please check immediately for air leakage. )
注：安装吸盘时应先安装十字交叉连接件。
供电板装好锁扣卡紧
将吸盘放在平滑位置连续按压抽空气阀直到活塞杆
上的白色圈置于在泵体内
( 如果白色圈在短时间内回到泵体外说明有漏气现象需要及时检查）
To Next Page
Loading...