Timberk TMS 08.CH - Page 13

ENGLISH
2. Switching on
Press ON/OFF button, symbols will be shown on the remote controller's display and POWER
indicator will ash on the control unit.
3. Setting a heating power mode
3.1. For TCH A2 infrared heater
3.1.1. Press HEAT button
3.1.2. To conrm the selection, press HEAT button again in 5 seconds after press HEAT
button, then a sound signal will be made, heating will be switched on, and heating
indicators will ash on the control unit.
3.2. For TCH A1N infrared heater
3.2.1. Press HEAT button, at that « » symbol will ash on the remote controller and start
blinking.
3.2.2. Press « » or « » button to select the high power mode ( « »symbol) or low
power mode ( « »symbol).
3.2.3. To conrm the selection, press HEAT button again in 5 seconds after press HEAT
button, then a sound signal will be made, heating will be switched on, and heating
indicators will ash on the control unit.
4. Setting timer functions to switch o the heater
4.1. When the heater operates in the heating mode, press « » button, then [00] value will
be shown on the display and start blinking.
4.2. Press « » or « » button to set the heater switch o time, with 1 hour increment, 0 to
13 hours. The display will show the countdown of time, remaining till the heater is switched
o.
13www.timberk.com  remote control block