10. Door switch
11. LCD
Replace door switch
1.Open the cover of the machine, pull out the data line of LCD.
2.Dismantle the plastic cover of the LCD you will see the switch
3.Screw off the bolts to replace the door switch.
18L/23L
1.Open the cover of the machine pull out the data line of LCD.
2.Dismantle the plastic cover of the LCD fixed by 6 bolts)
3.Then you will see the LCD
If the door switch does not work, the door close icon on screen will not appear
15
If the water level sensor works. The two pins shall be short circuit
if the distilled water tank is lack of water. As the picture.
12. W distilled water tankater level sensor of the
9. Water pump
If the water pump does not work the water can not jet into the seam generator, and can not generate the
steam ,and the pressure can not rise.
Check the water pump works or not. Pull out the connector
from the mainboard.
Measure the resistance of the vacuum pump.
The resistance should be less than 1k ohm.
If the water level sensor works. The two pins shall be short circuit
if the tank is full.
13. W water tankater level sensor of the used
To Previous Page
Loading...