www.tissot.ch 3/4 149_EN / 10.10
Quartz Chronographs GMT
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Simple timing
The "simple timing" function enables you to measure individual events.
A START
A STOP
Time readout (as per example in Fig. 1)
- 3 hours
- 5 minutes
- 57 seconds
B Reset
NB: Before each timing operation, the chronograph hands must be at their start points. If necessary, refer to
the RESETTING THE COUNTERS paragraph.
Note: All the timing functions are available with the crown pressed into position I.
ADD function
The ADD function enables you to measure consecutive events without having to reset in between. Each time
is added to the previous total (Fig. 2).
A START
A STOP Readout
A RESTART
A STOP Readout
A RESTART
A STOP Readout
B Reset counters
SPLIT-TIME function
The SPLIT-TIME function enables you to stop the hands to read an intermediate time without interrupting
the timing. When you restart, the chronograph hands "catch up" to the ongoing elapsed time.
A START
B SPLIT 1
Time 1 readout (as per Fig. 1)
- 3 hours
- 5 minutes
- 57 seconds
B RESTART (catchup)
B SPLIT 2
Time 2 readout (as per Fig. 3)
- 4 hours
- 45 minutes
- 20 seconds
B RESTART (catchup)
A STOP
Final time readout (cumulative time) (as per Fig. 4)
- 7 hours
- 55 minutes
- 45 seconds
B Reset counters
To Next Page
Loading...
Need help?
General
