6
TT5MTP26-2
Getting Started . . .
> If the cutting mechanism does not stop when the engine idles, switch the engine off
and stop using the machine. Then contact the authorised service centre.
>
Do not operate the machine with a damaged or excessively worn cutting attachment.
>
Do not operate the machine with cutting attachments other than provided. Do not
use with saw blades or ail blades.
>
Beware of blade thrust! Machines tted with blades can be thrown violently to the
side when the blade comes into contact with a xed object. A blade is capable of
amputating an arm or leg.
Additional safety warnings for pole pruner
> Before starting the engine, make sure the saw chain is not contacting any objects.
> Keep all parts of your body away from the saw chain. Do not hold material to be cut
when the machine is operating. Stop the engine before clearing jammed material.
One moment of inattention while operating the machine may result in a serious
personal injury.
> To avoid injuries due to falling branches, do not stand under the branches that you
want to cut off. Be aware of branches that may spring back and cause injuries. Work
at an angle of approximately 60°.
>
Keep an eye not only on the branches being cut, but also on falling material, to
avoid tripping.
>
Do not cut any wood that is lying on the ground and do not attempt to saw roots that
are protruding from the soil. Avoid immersing the saw chain in the soil at all costs,
as this could blunt the saw chain.
Additional safety warnings for hedge trimmer
>
Before starting the engine, make sure the cutter blades are not contacting any objects.
> Keep all parts of your body away from the cutter blade. Do not cut material or hold
material to be cut when the machine is operating. Stop the engine before clearing
jammed material. One moment of inattention while operating the machine may result
in a serious personal injury.
> While trimming, ensure not to come into contact with objects such as fence wire or
plant supports. This could cause damage to the cutter blades. Inspect the hedge to
be cut carefully and remove any wires or other foreign objects.
>
After changing the working angle, check whether both lock levers have clicked rmly
into place. If one of the lock levers remains open, the second could be unintentionally
be released by a branch and the cutter blade could swing down causing injuries.
Maintenance
>
Keep all nuts, bolts and screws tight to be sure the machine is in a safe working
condition.
>
Disconnect the spark plug connector before performing maintenance, except for
carburetor adjustments.
>
Keep the engine and petrol storage area free of grass, thatch, moss, leaves or
excessive grease to reduce the re hazard.
Safety information
To Next Page
Loading...
Need help?
General
