07
Getting started...
EN
TTB669PRW by TITAN
Safety information
>Never leave the product unattended when it is
connected to the power supply.
>Never move the product by pulling on the electrical
power cord.
>Do not allow vehicles to drive over the pressure hose.
>Do not move the product by pulling on the pressure
hose.
>When directed towards tyres, tyre valves or other
pressurised components, the high pressure jet is
potentially dangerous. Do not apply a jet stream and
always keep the nozzle at a distance of at least 30 cm
during cleaning.
>Protect all electrical conductors against the water jet.
>During start-up, the product may generate interference
on the electricity supply system.
>High pressure may cause parts to rebound: wear all the
protective clothing and equipment needed to ensure the
operator’s safety.
>Be aware of kick-back: grip the gun rmly when pulling
the trigger.
>Comply with the regulations of the local water supply
authority. Under EN 12729 (Type BA) the product can
be connected directly to the mains drinking water supply
only if the supply hose is tted with a backow preventer
device with drainage facility.
>Have maintenance and/or repair work on electrical
components to be carried out by qualied staff.
>Discharge residual pressure before disconnecting the
hose from the product.
>Check before each use, and at regular intervals, that all
metal fasteners are tight and the product’s components
are in good condition; inspect for broken or worn parts.
MNL_TTB669PRW_TIT_GB_V03_150818.indd 7 8/18/15 4:16 PM
To Next Page
Loading...
Need help?
General
