EN
29
In more detail...
TTI821GGT by TITAN
Operation
11b
11
13c
13d
13g
Fig. 22
3. Repeat until the worn part of the trimming line (13d) exceeds the distance to
the knife (11b).
4. Attach the battery pack and use the product as described. Excess line will
be cut by the knife (11b) and should always remain inside the radius of the
guard (11).
WARNING! The trimming line will be thrown out! Danger of injury
especially for bystanders!
Auto-feeding
1. With the product running, release on/off switch (3) to let it stop completely.
2. Press the lock-off button (2) and on/off switch (3) to start the product.
NOTE: The trimming line will extend about 3-5 mm with each stop
and start until the line reach the length of the knife. Avoid stop and
start frequently as the trimming line may auto-feed unintentionally and
causes waste a lot of line.
After use
1. Switch the product off, remove the battery back and let it cool down.
2. Attach the knife protector (11d) if necessary.
3. Check, clean and store the product as described below.
To Next Page
Loading...
Need help?
General
