Injection Molding Machine Chapter 1
1-7
V3.0
WARNING
1. WARNING OPERATORS NOT TO OPERATE MACHINE UNLESS THOUOUGHLY
INSTRUCTED ON SAFETY RULES AND OPERATIONS.
2. INSPECT AND CHECK OFF PROCEDURES FOR ELECTRIC， HYDRAULIC， AND
MECHANICAL SAFETY DEVICES.
3. MAKE SURE CLAMP CAN NOT BE CLOSED WHEN OPENING ANY SAFETY GATE.
DANGER
High Voltage-High Temperature
WARNING
1. Personnel who do not understand the machine shall not
be assigned to operate the machine.
2. Please check and confirm normal operation of the
mechanical， hydraulic， electrical safety devices.
3. Please confirm that when the safety door is open， the
mold shall not be clamped.
SPEC. SCEW DEPTH INTO PLATEN
ATTENTION
MOLD FIXING SCREW
M16 x P2.0
M20 x P2.5
M24 x P3.0
25 mm
30 mm
40 mm
CHECK PALLELELISM
MOLD
PLATEN
To Next Page
Loading...