TMC 30E - Page 44

Injection Molding Machine Chapter 4
V3.0
4-2A
1.5 Key definition
a) Manual key (green background)
MOLD OPEN MOLD CLOSE
EJECTOR BACKWARD EJECTOR FORWARD
MOLD HEIGHT MORE MOLD HEIGHT LESS
CORE 1 OUT CORE 1 IN
CORE 2 OUT CORE 2 IN
CORE 3 OUT CORE 3 IN
INJECTION SUCKBACK
CARRIAGE FORWARD CARRIAGE BACKWARD
AIR BLAST 2 AIR BLAST 2
CHARGE LUBRICATION
LOCK PIN IN LOCK PIN OUT
GATE OPEN GATE CLOSE
b) Mold key (yellow background)
MANUAL MODE PUMP ON/OFF
SEMI-AUTO MODE HETER ON/OFF
FULL-AUTO MODE ALARM ACKNOLEDGE
c) Page access key (white background)
CLAMP SETUP EJECTION SETUP
CORE SETUP INJECTION SETUP
CHARGE SETUP TEMPERATURE SETUP
DATA STORAGE SPC DATA
d) Function key
~
SOFT FUNCTION KEY DATA LOCK ON/OFF
BILL 2011/06/01