TMEC 200-1 - Page 12

Lay
the oil switch
in OFF position
if
the vehicle is not in
use.
Main fuel
tank: when
the
oil switch in this position,
the fuel
will
flow
into carburetor
from
main oil
path.
Second fuel
tank: when
the
oil switch in this posiiton,
the fuel
will flow
into carburetor
from
the spare oil
path.
Only can
use spare
oil when
the main
oil finished.
User should
add fuel I
time, the
spare oil's
max capacity is 1.5L.
Please check
that whether
the
oil switch is in the main
tank's position
every
time after
you
finish
adding.
If in
second position, you
will use
all without spare
oil.
Check
engine
oil level
Check
engine oil level
before
operating.
Keep center stand
and
the capacity
should be between
upper and
lower
limir.
l.start
engine for
3-5 mins
without loading.
2.stop
engine,
keep motor parking
in horizontal
road.
3.after
2-3 mins, put
out
oil
gauge,
clean it, insert again
but do
not fasten, put
out again,
observe the
oil level,
the level
should
between
the upper and
lower limits.
4.if necessary,
fill
oil to upper
limit, should
not exceed.
5.reinsert
oil
gauge.
6.check the
oil leakase.