2
1 2
3 4
5
- Refer to the list of device codes and
look for the 4-digit code that
corresponds to your equipment
brand.
If several codes are given
opposite the brand name,
try the first code first.
- Turn on the device that you wish
to operate.
- Press the device key
that you wish to operate.
- Keep the SET key pressed down
until the indicator light comes on.
- Enter the 4-digit code.
The indicator light flashes each time
that you enter a digit, flashes very
rapidly after the fourth digit, then
stays on.
The remote control is programmed.
NOTE:
• If the LED flashes slowly three times then stays on, this means that the code that you
have entered does not exist.
Try again.
• If all the functions do not work correctly, repeat the procedure with the next code.
ENGLISH
BY ENTERING THE DEVICE CODE
- If you are satisfied, press the OK
key to validate the programming.
- Repeat the procedure to program
the other devices.
7
- Try the different keys (except the
OK key) to test your device’s
functions.
6
To Next Page
Loading...