4
ENGLISH
BY AUTOMATIC SEARCH (IF YOUR EQUIPMENT IS NOT ON THE CODE LIST)
1
2
3 4
5
6
- Turn on the device that you wish
to operate.
- Press the device key
that you wish to operate.
- Press on the Power key. The search
is automatically launched.
Every 3 seconds a new code
is tested and a turn-off signal is
automatically sent to your device.
Be patient, you may have to try
more than one hundred times.
- Test your remote control’s functions.
If all the functions do not work
correctly, start the procedure again.
- Repeat the procedure to program
the other devices.
- When the device turns off, press
immediately on the OK key.
- Keep the SET key pressed down
until the indicator light comes on.
- Be sure to keep the remote control
pointing towards the device.
To Next Page
Loading...