Need help?Do you have a question about the Toa MX-101 and is the answer not in the manual?
General| Brand | Toa |
|---|---|
| Model | MX-101 |
| Category | Music Mixer |
| Language | English |
Defines wiring for XLR audio connectors: Pin 1 ground, Pin 2 cold, Pin 3 hot.
Explains that component and function descriptions are based on manufacturer usage.
Details input level, EQ, reverb send, XLR, and 1/4" inputs for each channel.
Covers Input Level, Reverb, Tape Level, Foldback Master, System Level, and EQ controls.
Describes the High Impedance (1/4") and Low Impedance (XLR) input connectors.
Explains the Power, Compressor, and Protection LEDs, and the protection circuitry notes.
Describes the 1/4" Speaker Jacks and the System Output Jack (XLR).
Covers the Power Switch (3-position) and AC Power Cord with grounding information.
Includes cautions for cooling, fuses, and a detailed Fault Protection Table.
Discusses rules for connecting equipment, emphasizing impedance and level matching.
Details actual load impedance, nominal use, sensitivity, and connector types for inputs.
Visual representation of the MX-101's signal flow and internal circuitry.
Graphical representation of signal levels throughout the MX-101's stages.
Details frequency response, harmonic distortion, hum/noise, EQ, and maximum voltage gain.
Provides data on input impedance, sensitivity, and output levels for system and foldback.
Lists power output, frequency response, damping factor, dimensions, weight, and power requirement.
Graphical plots showing frequency response for High Z input and 3-band EQ curves.
Diagrams for power band width, THD vs power output, and compressor input/output characteristics.
Graph illustrating the frequency response of the built-in reverberation effect.
Illustrations showing the physical dimensions and layout of the TOA MX-101.
To Next Page
