OPERATIONS
Set the wireless microphone's power
switch to ON. The corresponding
module's reception indicator lights.
Switch the power on. The
power indicator lights.
Adjust the volume control of the module of which reception indicator lights.
The level indicator lights depending on the intensity of input into the wireless microphone, regardless of the
volume control setting. When the indicator lights red frequently, your voice can be distorted at a microphone
circuit. In such cases, move your mouth away from the microphone so that the indicator lights yellow at a
maximum level. This is not needed if the indicator lights red only occasionally.
If the microphone is equipped with a sensitivity control, adjust the control so that the level indicator lights yellow
when spoken loud.
CONNECTIONS
When using with the 900 series amplifiers, connect the output of WT-770 with the following modules of
900 series.
Wall-mount dipole Mobile wireless Whip wireless
wireless antenna antenna antenna
YW-620 YW-610 YW-600
YW-600 : Direct mount type to the tuner. Requires no antenna cable.
YW-610 : Mobile type antenna. Antenna cable must be under 10 m (33 feet) in length.
YW-620 : Fixed mount type antenna having a built-in booster amplifier
Wireless microphones can be used in wide ranges.
Phone Jack : Mic modules
AUX modules
XLR : Mic modules
900 series amplifiers, etc.
–5–
To Next Page
Loading...
