EasyManuals Logo

TOHATSU MFS 2 Service Manual

TOHATSU MFS 2
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
2-9
2
4st 2/2.5/3.5 2007
Functional Limit Action To Be Taken
Clean to remove.
Clean to remove.
55.06mm (2.1677in) Replace if over specified limit.
0.06mm (0.0024in)
0.06mm (0.0024in)
54.90mm (2.1614in)
0.150mm (0.00591in)
Replace if under specified limit.
Replace if over specified limit.
Clean to remove.
Correct if possible (with #400 to 600 water proof sand paper), or replace.
Top Ring : 0.10mm (0.0039in)
Second Ring : 0.09mm (0.0035in)
Oil Ring : 0.17mm (0.0067in)
0.040mm(0.00157in) Replace if over specified limit.
13.97mm(0.5500in) Replace if under specified limit.
Top Ring : 0.50mm (0.0197in)
Second Ring : 0.70mm (0.00276in)
14.04mm(0.5528in) Replace if over specified limit.
0.060mm (0.00236in) Replace if over specified limit.
0.60mm (0.0236in) Replace if over specified limit.
20.015mm (0.78799in) Replace if over specified limit.
19.95mm (0.7854in) Replace if under specified limit.
0.05mm (0.0020in) Replace if over specified limit.
Adjust into specified range.
5.45mm (0.2146in)
5.44mm (0.2142in)
Replace if under specified limit.
5.55mm (0.2185in)
5.57mm (0.2193in)
Replace if over specified limit.
0.070mm (0.00276in)
0.080mm (0.00315in)
Replace if over specified limit.
2.0mm (0.08in)
2.0mm (0.08in)
Repair or replace if over specified limit.
33.2mm (1.31in) Replace if under specified limit.
23.78mm (0.9362in) Replace if under specified limit.
11.95mm (0.4705in)
12.95mm (0.5098in)
Replace if under specified limit.
0.03mm (0.0012in) Replace if over specified limit.
Check if rotating parts, sliding parts and sealing parts cause compression leakage.
Replace if severely damaged on the piston sliding surface, which cannot be repaired
with sand paper of No. 400 to 600, or if damaged over specified limit.
Replace if over specified limit.
Replace oil ring when top ring or second ring is replaced.
Replace if the gap is over specified limit only if cylinder liner wear is less than specified
limit.
Replace oil ring when top ring or second ring is replaced.
MFS2sec02070524.qxd07.5.243:12 PM ページ9

Table of Contents

Other manuals for TOHATSU MFS 2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TOHATSU MFS 2 and is the answer not in the manual?

TOHATSU MFS 2 Specifications

General IconGeneral
BrandTOHATSU
ModelMFS 2
CategoryEngine
LanguageEnglish

Related product manuals