TOHATSU MFS 2 Service Manual

5-26
Power Unit
4st 2/2.5/3.5 2007
27) Disassembly and Assembly of Crank
Shaft
1. Remove bearing 1 from crank shaft by using a
commercially available bearing puller.
2. Install new bearing 1 to crank shaft.
CAUTION
Do not reuse removed bearing. Replace
with new one.
Pipe 2 :
ø22mm
Flat Bar 3
1
2
1
3
Only flywheel side bearing 1 can be replaced.
1
Do not reuse.
1
Do not reuse.
MFS2sec05070524.qxd07.5.243:18 PM  ページ26

TOHATSU MFS 2 Specifications

General

Brand	TOHATSU
Model	MFS 2
Category	Engine
Language	English