Component Technical Manual Crypto VGA
Document Ref 942179-001 Rev 1 Page 6-7
6.8 Changing a bulb (Crypto VGA OPTs only)
In order to change the bulb, the printer and Crypto VGA units must be removed completely.
1) Follow the instructions in section 6.1 to enter Maintenance/Service mode.
2) Fully open the printer unit.
3) Unplug all connections on the printer unit.
4) Carefully lift up the printer unit and slide off its drawer runners.
5) Remove the printer unit completely and place in a safe position.
6) Locate the bulb and bracket inside the OPT head.
7) Twist the bulb 90
o
to release it from the bracket.
8) Carefully remove the bulb completely.
9) Fit new bulb into the bracket and twist to secure in position.
10) Place the printer assembly back into the unit on its drawer runners.
11) Plug in all connections on the printer unit.
12) Close the Crypto VGA printer drawer to reset alarm.
13) Return the relevant Crypto VGA to Normal mode at the POS.
14) Check operation of the new bulb.
Issue A
To Next Page
Loading...