Tokheim WWC T1 - APPLICATION MODE; 7.1 All Applications

Page 7-2 Document Ref 905675-001 Rev 2
Application Mode WWC T1 Set Up & Maintenance Manual
7 APPLICATION MODE
7.1 All Applications
Issue A
Display Explanations/comments
Press ON to enter Configuration.
conF
Press 3 to enter Application Mode.
APPLIc is flashing.
APPL I c
Press 7 to continue.
SEtUP
SetuP Pincd is flashing.
PIncd
Press 7 to continue.
En tEr Left - is flashing.
P I n c d Enter the 4 digit Technicians PIN code.
-
---
If an incorrect PIN code is entered then Error will flash for 3
Er ror
seconds before returning to previous menu to allow the
correct PIN to be entered.
Press 0 to exit PIN code menu.
To exit Application mode, ensure all nozzles are replaced then
conF press OFF.
Note : these menus are application dependent and may vary.
E n d This text is displayed briefly before the dispenser is
c o n F operational again.
If Error is displayed, check all nozzles are replaced.
Er ror