WWC T1 Set Up & Maintenance Manual Product Information
Document Ref 905675-001 Rev 2 Page 2-11
preset code button 1 button 2 button 3 button 4 Type
clear Value_1 Value_2 Value_3
1 Y 100 500 1000 Amount
2 Y 500 1000 5000 Amount
3 Y 1000 5000 10000 Amount
4 Y 200 500 1000 Amount
5Y 1510VOLUME
6 Y 11050VOLUME
7 Y 1000 2000 5000 Amount
8 Y 5000 10000 50000 Amount
9 Y 2000 5000 10000 Amount
10 Y 5000 10000 20000 Amount
11 Y 10 50 100 Amount
12 Y 500 1000 1500 Amount
13 Y 100 500 2000 Amount
Issue A
Push Button Methods
- Push buttons connected to the sensor bus or direct connections
- Push buttons connected to the IEB
Up to four buttons (three amount or volume and one reset button) are available
and can be connected to the sensor bus, direct connections or via IEB at each
filling position. In combination with preset valves, it is possible to fill up with the
fixed preset amount or volume.
The parameters used for local preset push buttons are as follows:-
- Y = function supported N = function not supported
- Value_1, Value_2 and Value_3
Each time a button is pressed, the amount or volume is increased by the
corresponding value. The volume is always defined in litres. The amount needs
to be updated using the comma position as defined by the specified country (for
further information, refer to Appendix B).
Example 1
If Value_1 = 500 and Spain is selected (Country code 0034), each push of the
button increases the amount by 500 Ptas because the “comma position” of the
amount display is 0 (refer to Appendix B).
→ (0034 SPAIN 0 / 2 / 1)
Example 2
If Value_1 = 500 and The Netherlands is selected (Country code 0031), each
push of the button increases the amount by 5,00 Dfl. since the “comma position”
of the amount display is 2 (refer to Appendix A).
→ ( 0031 NETHERLANDS 2 / 2 / 3)
Note: To select the push button functionality via the IEB, the jumper W300
on the IEB must be closed (refer to Appendix D for Jumper Positions).
To Next Page
Loading...