Page 2-20 Document Ref 905675-001 Rev 2
Product Information WWC T1 Set Up & Maintenance Manual
Issue A
Kernel version >= 02.xx
OC Option Controller Board
HC Hydraulic Controller Module
CS1R CSD 1 Right
CS2R CSD 2 Right
CS1L CSD 1 Left
CS2L CSD 2 Left
SO Sound Option Module
EC VRC Module
UA User Access Module
H1 Hydraulic Option Module 1
H2 Hydraulic Option Module 2
H3 Hydraulic Option Module 3
H4 Hydraulic Option Module 4
D1 Diagnostic
GCI Kernel
Applic Application
CHS Checksum of main controller Eeprom
(containing the kernel and the application)
Disable Station Manager PIN
This function will enable access via an additional input if the Station Manager
PIN is not known. It is application dependent and therefore only active when
the calculator head is open.
LPG
When one of the LPG set ups (set up 60 or 61) is selected, the following functions
will be supported:-
•The LPG Delay Menu defines the use of nozzle switches or Deadmans buttons
value = 0 Nozzle Switch used
Ignore Deadmans Button when the nozzle is replaced
value = 1 to 29 Deadmans Button only
Delivery will be started when the button is pressed.
The end of a delivery is determined by the value
(delay in seconds) after the button is released
•The LPG nozzle menu defines if the nozzle function is supported (yes or no).
•The LPG Pulse menu allows the meter selection (during set up only)
1 Tatsuno meter : 0.5L/rev (one pulse equals 1 cl.)
2 Schwelm meter : 1L/rev (one pulse equals 2 cl.)
For more information on LPG options, refer to section 3.
EMPD
This function enables the WWC to operate a dispenser without mains power
being present. The pump is operated by a cranking device and the calculator is
operated using battery power.
Note : Special hardware is needed to support this function.
To Next Page
Loading...