Tokheim WWC T1 - Page 88

Page 6-20 Document Ref 905675-001 Rev 2
Maintenance Modes WWC T1 Set Up & Maintenance Manual
Issue B
Display Explanations/comments
The unit price display will alternate between Test and 0.
The display reading setting allows meter information to be
displayed on the volume/amount display. Depending on the
test type, the following information will be displayed during a
delivery:-
0 = normal readings i.e. amount/volume
1 = amount display shows total flow;
volume display shows total volume
2 = amount display shows the volume of meter 1;
volume display shows volume of meter 2
3 = amount display shows flow rate of meter 1;
volume display shows flow rate of meter 2
Press 7 to save and continue.
t E S t Test Type menu.
tYPE Press 9 to change this value (if flashing).
tSt
x
If enabled, the unit price display will alternate between TSTx
and x (actual test type).
Press 7 to save and continue.
Note : In the case of IFSF protocol, only the Pulser Hide menu is displayed.