Why is my Tokyo Gas Engineering Solutions Corporation Gas Detectors making noise when sound is off?
If your Tokyo Gas Engineering Solutions Corporation Gas Detectors device makes a sound even when the sound is turned off, it might be because the battery is low. When the battery is low, you'll hear a sound when you press a button or try to operate something.
How to turn on Tokyo Gas Engineering Solutions Corporation Gas Detectors?
If your Tokyo Gas Engineering Solutions Corporation Gas Detectors device isn't starting when you press the power button, make sure you press and hold the power button for about 2 seconds until you hear a beep. Also, check if the battery has enough power. If not, replace it with a fully charged or new battery.
Why is my Tokyo Gas Engineering Solutions Corporation Gas Detectors so quiet?
If you can't hear the measurement sound “beep...” on your Tokyo Gas Engineering Solutions Corporation Gas Detectors, check the “Sound” setting to see if the volume is turned off. If it is, turn the volume up.
General| Model | LM2B03E-SBA |
|---|---|
| Type | Laser Methane Detector |
| Target Gas | Methane (CH4) |
| Detection Principle | Laser Absorption Spectroscopy |
| Power Supply | Rechargeable lithium-ion battery |
| IP Rating | IP54 |
| Laser Safety | Class 1 Laser Product (IEC 60825-1) |
| Battery Life | 8 hours (continuous use) |
| Ingress Protection | Dust and splash resistant |
To Next Page