Need help?Do you have a question about the Tokyo HL-130U and is the answer not in the manual?
Indicates output power level with 6 LEDs, up to approximately 100W.
Lights when output is open/shorted or DC voltage exceeds 15V, indicating protection is active.
Allows selection between 'HI' (full power) and 'LO' (half power) output levels.
Selects operating mode; SSB has a one-second relay change-over delay.
Enables amplification of received signals via a low-noise GaAs FET when activated.
When OFF, the amp enters 'THRU' state, bypassing internal components.
Indicates when DC power is supplied and the main power switch is in the 'ON' position.
Lights when the RX switch is ON, allowing pre-amp use even with the power amp off.
Details connecting remote control wires and RF coaxial cables to the transceiver and antenna.
Covers ventilation, heat, SWR, DC voltage, power supply type, and internal adjustments.
To Next Page
General