EasyManua.ls Logo

tomado TFT4702W - Using the Appliance; Adjusting the Temperature Settings; Operating Tips for Efficiency

tomado TFT4702W
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN - 20


The control unit of the appliance is located at the back of the appliance. Check that the thermostat is in posion OFF.
Check that the voltage corresponds with what is stated on the informaon plate and insert the plug in the socket.
Adjusng the temperature
By means of the thermostat you are able to switch on the appliance and change the temperature in the freezer.
The possible posions of the thermostat:
Posion OFF - no cooling, but there is power
Posion MIN - highest temperature, least cold
Posion NORMAL - opmum temperature
Posion MAX - lowest temperature, coldest
Set the temperature with the thermostat and select a posion between MIN and MAX. We recommend seng the appliance to
posion NORMAL. The appliance will now cool connuously unl the set temperature has been reached. Allow the appliance
to reach the required temperature with no food. Usually this will take 2 to 3 hours. Aer that, you can set the thermostat to the
required posion and ll the appliance with food.
To switch the appliance o, set the thermostat to posion OFF and unplug the appliance.
Aenon:
The ambient temperature, the frequency of opening the door and the posion of the appliance have an eect
on the temperature in the appliance. Take this into account when seng the thermostat.
Do not place hot food in the appliance.
You should never place hazardous, highly ammable or explosive substances such as alcohol, acetone or petrol
in the appliance, because there will be a hazard of explosion.
Carefully package meat and sh to prevent unpleasant smells.
Do not place food items in contact with the cold wall at the back of the appliance.
Leave sucient space between the dierent foods, to allow the air to circulate properly.
Do not leave the door open for longer than necessary.
High ambient temperatures have a negave eect on energy use. Keep the appliance in a posion away from direct sunlight
or other sources of heat.
Keep venlaon openings free. Clogged openings lead to higher use of energy.
Try not to open the door too oen, especially when the weather is wet and hot. Once you open the door, mind to close it as
soon as possible.
Turn the thermostat to a lower seng when the circumstances allow it.
Before storing fresh cooked food, make sure the food has cooled at least to room temperature.
Ice and frost layer increase energy consumpon, so clean the appliance as soon as the layer is 3 to 5 mm thick.
If the gasket is damaged or if it turns out that the sealing is poor, the energy consumpon is substanally higher. To restore
eciency, replace the gasket.
Always consider the instrucons, otherwise the energyconsumpon is substanally higher.
To avoid contaminaon of food, please respect the following instrucons
- Opening the door for long periods can cause a signicatn increase of the temperature in the compartments of the appliance.
- Clean regularly surfaces that can come in contact with food and accessible drainage systems.
- Store raw meat and sh in suitable containers in the refrigerator, so that it is not in contact with or drip onto other food.
- Two-star frozen-food compartments are suitable for storing pre-frozen food, storing or making icecream and making ice
cubes.
- One-, two- and three-start compartments are not suitable for the freezing of fresh food.