Version 1.1 2014 IC-TKIC1B-01 Copyright by Indoorcycling Group GmbH 2014 | www.indoorcycling.com
ABOVE GRAPHICS SHOWS THE
RIGHT SIDE OF THE BIKE
(RIDING POSITION)
D
C
PREVENTIVE
MAINTENANCE
Re-check the amount of play in the belt as
described at the beginning of this step. If
necessary, readjust the belt.
Finally, retighten the two outer adjustment
nuts (C) and the two axle nuts (B), and
reattach the maintenance covers. To avoid
damage to the ywheel bearings, do not over
tighten the axle nuts (B). Unusual noises or
vibrations are indications that the belt has
been over tightened or that the ywheel is at
a wrong angle.
3.
To Next Page
Loading...
