Copyright by
CYTECH GmbH 2008
ENG 3
www.indoorcycling.com
WICHTIGE SICHERHEITSHINWEISE
1. It is the sole responsibility of the owner
to ensure that all users of the indoor
cycle are informed of all warnings and
precautions by an authorized trainer or
instructor prior to use.
2. Operate and maintain the indoor cycle
only as described in this manual and
after proper assembly and functionality
check (see page 5-10).
3. Keep the indoor cycle indoors, away from
moisture and dust. Do not place the
indoor cycle in a garage or covered patio
or near water.
4. Place the indoor cycle on a level surface.
To protect the floor or carpet from
damage, place a mat beneath the indoor
cycle. Make sure that there is adequate
room around the indoor cycle to mount,
dismount, and operate it.
5. Regularly inspect and properly tighten all
parts of the indoor cycle as
recommended in this manual. Please
replace defective parts immediately and
do not use the bike until repair is
performed. Only use original parts from
the manufacturer.
6. Children under the age of 18 should only
be allowed use of the indoor cycle with
parental approval and if guided by a
specially trained instructor.
7. The indoor cycle should not be used by
persons weighing more than 290
lbs/130 kg.
8. Always wear appropriate athletic
clothes and shoes while operating the
indoor cycle. Do not wear loose clothes
that could become caught on the
indoor cycle or shoes with loose laces.
9. Before using the indoor cycle, make
sure that you are familiar with the
setup/operation of the indoor cycle
(see pages 8-12).
10. The indoor cycle does not have an
independently moving flywheel
(wheel); the pedals will continue to
move together with the flywheel until
the flywheel stops.
11. Always regulate the flywheel
resistance so that your pedalling
motion is controlled (see page 8-10).
12. Keep your back straight while using
the indoor cycle; do not arch your
back.
13. If you feel pain or dizziness while
exercising, stop immediately, rest and
cool down and consult a physician.
14. If replacement parts are needed, use
only manufacturer supplied parts.