Tomahawk TPC170H Operation And Instruction Manual

11
2.5.2 Gas Engine with Electric Starter
1. Do not actuate starter for more than 20 seconds at a time. If engine does not start, wait
1 minute before repeating attempt. If engine does not start aer two attempts, trace the
cause according to the Diagnosis Chart.
2. Make sure the key is always in the (1st) position when the engine is running. Make sure
that all warning lights are o when the engine is running. For engines with a starting
panel equipped with engine protection, make sure the OK light only is ON.
3. Aer starting, idle speed for a few minutes according to table:
10. Take the handle and pull the rope soly until it is extended to its full limit. Let the
rope rewind completely. Start the engine pulling strongly on the rope.
11. To stop the engine, move the accelerator lever into the stop position.
1st Position - Warning light ON 2nd Position - Starting
Temperature Time
δ - 20° C
5’
- 20° C / - 10 ° C 2’
- 10° C / - 5 ° C 1’

Tomahawk TPC170H Specifications

General

Brand	Tomahawk
Model	TPC170H
Category	Power Tool
Language	English