| SIL VER BU LLE T & AR ROW
PA GE | 2 1
Display Controller
The display comprises a battery condition display, plus and minus power output
buttons with power level indication and a "non-pedalling soft start" button.
• The battery display automatically lights when the battery main switch is turned
on and indicates the remaining battery capacity with four LED diodes.
• Pressing the "plus" or "minus" buttons will raise or lower the delivered battery
power in 6 stages indicated by three solid or flashing LED diodes, i.e. 1 flashing =
power level 1, 1 solid = power level 2 and so on. With no power LED's lit, the
power is off. Press the "plus" button to return to power level 1. Switch off at the
main switch after use.
• Pressing the "A" button will engage start power without the need to turn the
pedals. This starting aid is limited to 6kph and should not be used for prolonged
periods. Always set the power level to 1 (one) when using the "A" Button.
See Power-Assist Motor Video
9. General Product Care.
• Keep the product clean.
• Store is in a dry, moisture-free environment. Do not leave exposed to the
elements for prolonged periods of time.
• Do not re-route any mechanical control cables, particularly gear cables. This will
alter gear-hub settings.
• Keep the battery charged in accordance with the above instructions.
• Do not pressure wash electrical wires or components.
• Keep the tyres inflated to the pressure stated on the tyre wall. Do not exceed
this pressure.
• Lubricate all chains with light oil monthly and when laying up at season's end.
• Protect all metal parts with a light spray oil at season's end.
• Do not use the vehicle if any parts are loose or do not work properly. Investigate
and remedy before re-use.
• Check all safety devices at the beginning of each journey. Do not use the vehicle
if any are defective.
To Next Page
Loading...