7. Setting Up the Pedals and Seat to suit the Rider.
(Ergonomic Adjustment)
7.1 Models with Pre-Set “Pedals and Seat” models.
Adjusting Setup.
The Standard “Pedal and Seat” setup for a single rider (leg
length and arm reach respectively) is factory set after custom building, to the
riders own physiology, however, both can be adjusted as follows.
Seat.
Beneath the left and right side of the seat are two hexagon headed screws.
Slacken each screw by one or two turns only and slide the seat to the desired
position. Re-clamp the screws to secure the seat. Note that adjusting the seat
will affect the leg length therefore adjustment of the pedals may also be
necessary.
Pedals
Remove the chain, slacken the Sliding Bottom Bracket clamp, and roughly adjust the
Sliding Bottom Bracket to achieve a comfortable leg stretch. A new chain made to
a suitable length is then attached. The Sliding Bottom Bracket is then finely
adjusted and re-clamped. Chain tension must be neither slack nor tight, but quiet
running and free to move.
7.2 Models with Pre-Set pedals and (optional) sliding seat.
To slide the seat on models with Pre-set pedals, sit on the seat and move the seat
by pulling the seat slide knob outwards until you are at a comfortable leg
length. Release the Knob to lock the seat.
Note that the pedal position can be adjusted by following the pedal adjustment
procedure described above.
| SIL VER BU LLE T & AR ROW
PA GE | 6
To Next Page
Loading...