Putting your pump together
Each time you use your breast pump,
check all parts of the pump and
power unit for any damage.
Wash your hands with soap and
water and dry thoroughly before
handling your breast pump.
Make sure that all parts of the pump
have been washed, cleaned and
sterilized, and are completely dry.
1. Place the clear diaphragm
in the top of the body and
push down gently to get a
good seal.
2. Place the clear diaphragm
cap over the diaphragm
and push down gently
to seal.
3. Place the purple lid over
the top of the body and
turn it clockwise until it
clicks closed.
4. Push the soft, silicone cup
into the widest part of the
horn and smooth its lip
evenly over the edge.
Work your way all around
the rim to make sure the
cup fits smoothly, evenly
and securely. The two
dimples in the cup should
be clear to allow air into
the horn.
5. Now smooth the lip of the
silicone cup around the
narrow end of the horn in
the same way.
6. Push the horn with cup
attached onto the body
until it’s fully engaged and
secure. Turn your pump
handset upside down.
7. Insert the purple
duck-bill valve. Gently
squeeze the sides of the
valve to make sure it’s
open.
8. Screw in a Tommee
Tippee Closer to Nature
or Advanced Anti-Colic
bottle. This breast pump is
designed to fit all Tommee
Tippee Closer to Nature
and Advanced Anti-Colic
bottles (excludes Tommee
Tippee Closer to Nature
glass bottles) and Express
& Go / Pump & Go milk
pouches with adaptor rings.
9. Place the assembled pump
on a flat surface. Connect
one end of the air tube to
the purple lid of the pump
body and the other to the
power unit. It goes in the
hole at the side.
Once you’ve fitted and used it, you don’t have
to take the silicone cup out of the horn unless
milk or dirt becomes trapped inside. Then you
can ease the edges of the cup from the horn
and gently pull them apart for cleaning.
4
1
2
3
5
6
8
7
9
1
4
To Next Page
Loading...
