About voice control
Instead of tapping the screen to control your TomTom GO LIVE, you can use your voice to control
your GO LIVE.
For example, to increase the volume on your GO LIVE, you can say "Increase volume" or "Volume
50%."
To view the list of available commands, tap Help in the Main menu, tap Product manuals and then
tap What to say.
Important: Voice control requires a voice that speaks street names. When there is no voice that
speaks street names installed and selected on your TomTom GO LIVE, this feature is not available.
To select a voice that speaks street names, tap Voices in the Settings menu, then tap Change voice
and select a voice that speaks street names.
Using voice control
Voice control is switched on by default if it is supported for your chosen language.
To switch off voice control and remove the button from the Driving view, tap Voice control in the
Settings menu and select Disable voice control.
The following example shows how to use voice control to plan a trip to your Home address:
1. Tap the microphone button in the Driving view to turn on the microphone.
You see a screen with examples of commands you can say.
Tap What to say to see a full list of commands you can say. Alternatively, tap Settings in the
Main menu, tap Voice control and then tap What to say.
2. When you hear "Say a command" followed by a tone, say a command of your choice. For
example, you can say "Drive home." Your GO LIVE is only ready to listen after your hear the tone.
While you are speaking the microphone monitor shows how well the device can hear your voice:
To Next Page
Loading...
