tormek T-2 - Diamond Wheel Important Information; Mounting the Sharpening Clamp; Mounting the Angle Pointer; Positioning the Jig on the Machine Axis

4
EN
Important Information Regarding
the Diamond Wheel
Always clean the knife before sharpening, otherwise the function of the grinding wheel can
be altered.
At rst usage, the diamond surface will seem aggressive but after a short break-in period,
the diamond crystals will stabilise to a uniform level to give a ner surface. This normally
takes 2–5 sharpenings.
If necessary clean your sharpener with water, washing-up liquid and a nylon brush.
Store the machine in a dry area.
3. Mounting the clamp
4. Mounting the pointer
5. Positioning the jig on the axis