8. To secure the men, align the holes in each man with the holes in the rod. Using the rod
support block under the rod near the man, place the roll pin in the man hole (slot in
the roll pin down toward the foot) and tap it through the man with a hammer, until it is
flush on both sides
9. To remove the men, place the pointed
end of the included roll pin punch into the
roll pin and drive it out. The roll pins are
reusable.
10. Mount the score assemblies at each
end of the table.
11. Level the table by rotating the levelers
on the bottom of each leg.
12. Lubricate the game at least once a
month.
a. Wipe each rod with a clean dry cloth.
b. Pull the handle end of each rod out towards you and apply one drop of silicone
to the top of the rod, approximately one inch from the outside of the game.
c. Continuously spin the rod while pushing it in and pulling it out of the game.
d. Remove any excess silicone with a clean soft cloth.
VISIT WWW.VALLEY-DYNAMOPARTS.COM FOR WARRANTY REGISTRATION
AND REPLACEMENT PARTS ORDERS. ENJOY YOUR NEW TORNADO TABLE.
To Previous Page
Loading...
Need help?
General