- PLAY-PAUSE, stops the broadcast for at while and resumes playback
! By default the receiver has built-in 5-minute memory
! PAUSE is also used if your broadband connection for a short period does not send enough data. Here the
PAUSE feature is used to shortly enable a little more "buffer"
- DISPLAY removes the menu from the screen and returns to TV / Radio
- STANDBY is the red button in the top right corner
- VOLUME (UP/DOWN arrow keys) controls the sound that BOXTV senda to your TV. The TV remote
controls the overall volume.
- INFO retrieves data from your broadband connection. This function is a general indication of the signal
received from the router. This is not a precise measurement of the total signal, but provides an insight into
your ADSL connection data packets which are sent to your BOXTV receiver
ERROR "I can’t enter the main menu"
FIRSTLY ALWAYS CHECK If you are on the correct HDMI input on your TV. SECONDLY ALWAYS INSPECT if
you have access to the Internet via your PC.
• Error 1 - The middle light is red: no network cable connected
• Error 2 - Upper light flashes green / red: Loading data / searching for connection. Wait 20-60 seconds
• Error 3 – Top light is red: There is no connection to the DSL / Internet, try your local internet through your
computer. Check if the network cable is properly connected to both the router and BOXTV receiver.
• Error 4 - The broadcast is unstable or judders continuously:
- Firstly try ”PLAY/PAUSE” for 1 minut and see if that extra buffer solves your problems.
- Check if your Internet connection retrieves data with 1Mbit or more. (INFO)
- Restart the receiver on the main switch.
! See www.danelca.com - BOXTV – Technical requirements
To Previous Page
Loading...
Need help?
General