45
DLNA Client This option will enable the DLNA client software. The DLNA client is
software that allows extracting and playing content from DLNA servers located in the same LAN.
Remote Control App Enables/Disables the remote control App option for mobile phones and
tablet devices.
Device Management Section
Audio In/Out Config* This configuration allows setup of audio devices in case there are more than
one audio device present in the system
Microphone Device* This is the device that is used to manage the microphone.
Video Card* This is the video card device that is used by default.
Video Output* This is the video output type. Usually this is a selection to allow video
output toggle between S-Video and VGA interface.
Resolution This option allows the desired resolution for the device to be set. To reset
the device resolution to default, follow these steps:
1. Press Power button (the Power button becomes RED)
2. Press "Home" button
3. Press Power button (the power button becomes BLUE)
Page Borders This option defines the number of pixels from the borders of the screen that
will stay unused by the GUI interface. This is required so that the GIU is completely visible on all TV sets.
Video Standard* This is the output analog video standard.
Max Horizontal Sync Freq* This is the horizontal sync video frequency in kHz
Max Vertical Sync Freq* This is the vertical sync video frequency in kHz
Enable Phone Video* This is used to enable Video phone conferencing and Video phone calls.
The device requires a camera.
Location Management
Country This is the location of the device. The information used for accurate
Weather information.
Language This is the language selection of the user. The selection allows service
To Next Page
Loading...
Need help?
General