EN - 24
The installation and repairing procedures should always carried out by the Authorised Service Agent in order to avoid
possible risks. The manufacturer shall not be held liable for damages that may arise from procedures carried out by
unauthorised persons. Repairs may be carried out by technicians only. If a component has to be replaced, ensure that
only original spare parts are used.
Improper repairs or use of non-original spare parts may cause considerable damage and put the user at considerable
risk.
Contact information for your customer service can be found on the back of this document.
Function-relevant genuine spare parts according to the corresponding Ecodesign order can be obtained from
Customer Service for a period of at least 10 years from the date on which your appliance was placed on the market
within the European Economic Area.
TROUBLE
CODE
POSSIBLE FAULT WHAT TO DO
FF
Water inlet system failure
Make sure the water inlet tap is open and water is flowing.
Separate the inlet hose from the tap and clean the filter of
the hose.
Contact for service if the error continues.
F5
Pressure system failure
Contact for service.
F3
Continuous water input
Close the tap and contact for service.
F2
Inability to discharge water
Water discharge hose and filters may be clogged.
Cancel the program.
If the error continues, contact for service.
F8
Heater error
Contact for service.
F1 Overflow
Unplug the machine and close the tap.
Contact for service.
FE Faulty electronic card Contact for service.
F7 Overheating Contact for service.
F9 Diverter position error Contact for service.
F6 Faulty heater sensor Contact for service.
HI High voltage failure Contact for service.
LO Low voltage failure Contact for service.
AUTOMATIC FAULT WARNINGS AND WHAT TO DO
To Next Page
Loading...
Need help?
General