Tornador® is a registered trademark of ECP Inc. ©2021
Tornador® covered by one or more of the following: U.S. Patent Nos. 6,883,732; 8,480,011; 8,690,077; 9,475,071; 10,182,696; 10,189,034; 10,343,177; 10,562,078; 10,730,062;
Taiwanese Patent No. I617360; U.S. Design Pat. Appl. Nos. 29/756,918; 29/756,919; 29/756,920; 29/756,921; 20150000705; 20150375272; Taiwan Application No. 103135808.
TROUBLESHOOTING
PROBLEM:
• Tip will not oscillate
• Tip moves slowly
• Tip drips uid
• Will not dispense liquid
SOLUTION:
• Check for low air pressure
• Check for dirt build-up and clean
• Keep liquid valve in the horizontal position when not in use
• Check pickup tube for debris and rinse out
LIMITED WARRANTY
“90 day limited manufacturer’s warranty against manufacturing & part defects.” Warranty will be voided, if it is used
for anything other than the intended use of the Tornador
®
cleaning tool. Use of any products, other the Tornador
®
products, with or in the Tornador
®
cleaning tool, voids warranty.
CARE & MAINTENANCE
1. Avoid dropping the gun on the oor, disconnect when not being used.
2. Turn liquid valve to the horizontal position after use to avoid dripping from tip.
3. Tighten the jar while holding the lid to avoid loosening or stripping gun assembly.
4. Keep the cone of the gun clean by removing the cone and rinsing frequently.
NOTE: After every use, place nozzle 2-3 inches into a bucket of soapy water while
depressing the trigger once or twice to quickly remove dirt buildup in the cone. This will
prevent premature wear.
Page 2
To Previous Page
Loading...